Commercial Reverse Osmosis Systems in Indianapolis

Zenith supplies, installs and maintains commercial reverse osmosis for Indianapolis businesses. There are four systems: a compact tankless unit, single and twin membrane systems, multi-membrane frames up to 20,000 gallons a day, and custom membrane systems for large sites. Each one is sized to your water test and your peak hour before we quote it.

Free on-site consultation · Written quote before any work starts · Installed and serviced by our Indianapolis team

Four systems at a glance

SystemOutputUsually fits
Compact tankless500 gallons a dayCafes, offices, pharmacies, labs
Single and twin membrane1,600 or 3,200 gallons a dayRestaurants, commercial kitchens, beverage lines
Multi-membrane frame2,500 to 20,000 gallons a dayCar washes, production lines, large kitchens, light industrial
Custom membrane systemSpecified to the siteLarge commercial sites

Outputs are the manufacturers’ rated figures. Reverse osmosis produces less in colder water, so every system is confirmed against your water test and your peak hour before we quote it.

Compact tankless system

Compact tankless commercial reverse osmosis unit with three white filter housings in a black case

500 gallons a day

A compact unit that makes treated water on demand, with no storage tank. It fits under a counter or in a back-of-house cabinet. Indicator lights show when a filter is due or when something needs attention, and the unit protects itself against running dry.

Good for cafes, restaurants, pharmacies, spas and labs, and a useful add-on to a softener where only the drinking and coffee water needs treating.

Four filtration stages

  1. 5 micron sediment filter
  2. Coconut shell carbon filter
  3. Reverse osmosis membrane
  4. Coconut shell carbon post-filter
SpecificationCompact tankless system
Treated water18 to 20 gallons an hour
Feed water used37 to 40 gallons an hour
FiltrationFour stages
Storage tankNone needed
Power220 volts
Size16.1 in high, 16.3 in wide, 12 in deep
Supplied withDrinking water faucet, connection fittings and service wrenches

Rated at 77°F feed water with 1,000 mg/L dissolved solids.

Single and twin membrane systems

Commercial reverse osmosis system with one membrane housing, pump and pre-filter on a blue frame

1,600 or 3,200 gallons a day

A frame-mounted system built around the essentials. One 4 by 40 inch membrane makes 1,600 gallons a day and two make 3,200. A good fit for restaurants, commercial kitchens and beverage lines with steady daily demand.

  • 3/4 HP stainless steel multi-stage centrifugal pump
  • Low-pressure protection
  • Flow meters for treated water and concentrate, with a concentrate control valve
  • Low-pressure membranes in fiberglass housings
  • High-pressure hoses rated for 300 psi
  • Powder-coated frame with mounting holes in the legs
OutputMembranesPower
1,600 gallons a dayOne, 4 by 40 inch110 or 220 volts
3,200 gallons a dayTwo, 4 by 40 inch220 volts

This series has no concentrate recycle valve. The multi-membrane frames do.

Multi-membrane frame systems

Multi-membrane commercial reverse osmosis system with white membrane housings on a blue steel frame

2,500 to 20,000 gallons a day

Seven sizes on one frame design, from one membrane to eight, for commercial and light industrial sites that need 1.7 to 13.8 gallons of treated water a minute.

An integrated recycle valve recovers 50 to 75% of the feed water, and float switch and pre-treatment interlocks stop the system when the storage tank is full or the softener is regenerating.

For car washes, production lines, large kitchens and light industrial use.

Standard on every size

  • Powder-coated carbon steel frame with extended legs
  • High-pressure multi-stage centrifugal pump on a replaceable motor mount
  • Low-pressure membranes that run at 100 psi, in 300 psi fiberglass housings
  • Integrated recycle valve and pump throttle valve
  • Low-pressure switch, plus float switch and pre-treatment interlocks
  • Flow meters for treated water and concentrate
  • Liquid-filled pressure gauges
  • Stainless braided hoses and schedule 80 PVC fittings
  • Front-mounted 5 micron pre-filter

Options

  • Digital controller with a treated-water TDS display
  • Interval fast flush or permeate flush
  • A second TDS reading on the feed water
  • Pre-filter, post-filter and inter-stage gauges
  • Bladder tank control for pressurized storage
  • Stainless steel membrane housings
  • Wall-mount frame

Sizes

Output (GPD)MembranesTreated water (GPM)Feed water (GPM)Pump (HP)
2,50011.7360.75
5,00023.4770.75
7,50035.2101.5
10,00046.94121.5
12,50058.68173
15,000610.4203
20,000813.8253

Rated at 77°F feed water with 4 by 40 inch membranes. Feed water figures need at least 35 psi at the inlet while the system runs. All sizes run on 220 volt single-phase power. The inlet is 3/4 inch up to 10,000 gallons a day and 1 inch above that. Every size ships at 34 by 34.5 by 58.5 inches and weighs 124 to 248 pounds. Maximum operating pressure is 160 psi.

Custom membrane systems

Custom multi-membrane reverse osmosis system

Built to your site

For large commercial sites whose demand or feed water does not fit a standard size. We specify the system around your water test and your peak demand, then quote it in writing with the site work and service schedule set out before anything is ordered.

What we specify

  • Number and arrangement of membranes
  • Housing material, fiberglass or stainless steel
  • Controls and monitoring
  • Pre-treatment: softening and carbon filtration
  • Storage tank and delivery pump
  • Service schedule

What goes in front of the membranes

Commercial membranes specify feed water below 1 grain of hardness with no free chlorine. Indianapolis city water arrives at about 19 grains. That is why we quote softening and carbon filtration ahead of the reverse osmosis wherever your water test calls for it. It is what makes the membranes last.

See the complete commercial system, or how we size reverse osmosis.

Book your free on-site consultation

Tell us about your site and we will call you to set a time.

What the visit includes

  • Your water tested at your site
  • Any system already installed, inspected
  • A recommendation sized to your results
  • A written quote before any work starts
  • No cost and no obligation

What happens next

  1. We call you to set a time that suits your site.
  2. We visit and test your water on site.
  3. You get a written quote sized to your results.

Prefer to talk? Call (317) 690-4172 and ask for the commercial team.

Commercial reverse osmosis questions

What size commercial reverse osmosis system do I need?

Start from your peak hour, not only your daily total. We size the system above your daily demand so it runs part of the day, and add a storage tank so busy hours draw from the tank. A cafe using 300 gallons a day usually suits the compact tankless system with storage. Larger kitchens, car washes and production lines move up to the membrane frames. We confirm the size after testing your water on site.

Does a commercial reverse osmosis system need a softener in front of it?

In Indianapolis, yes. Membranes specify feed water below 1 grain of hardness with no free chlorine, and city water here arrives at about 19 grains. Softening and carbon filtration ahead of the membranes stop them fouling early.

How much water does a commercial reverse osmosis system send to drain?

It depends on the system and your water. The multi-membrane frames have a recycle valve and turn 50 to 75% of the feed water into treated water. The compact tankless system uses 37 to 40 gallons of feed water an hour to make 18 to 20 gallons of treated water, which is about half.

What power does a commercial reverse osmosis system need?

The compact tankless system runs on 220 volts. The 1,600 gallon system runs on 110 or 220 volts and the 3,200 gallon system on 220 volts. The multi-membrane frames run on 220 volt single-phase power. We check the supply at your site during the consultation and confirm it in your written quote.

How much room does a commercial reverse osmosis system take?

The compact tankless system is about 16 inches high, 16 inches wide and 12 inches deep. The multi-membrane frames ship at 34 by 34.5 by 58.5 inches in every size. Pre-treatment and a storage tank need their own floor space, which we measure at the consultation.

How much does a commercial reverse osmosis system cost?

It depends on the size, the pre-treatment your water needs, storage and the installation work. We give you a written quote after the on-site consultation, and the consultation is free.

Specifications are the manufacturers’ published figures, and feed-water requirements are the membrane manufacturer’s published specification. Final figures are confirmed in your written quote.

Book your free water test

We test your water at home, show you your Zenith Water Health Index score and give you a written quote. No obligation.

Or call (317) 690-4172

Why Zenith

  • Free in-home water test with your Water Health Index score
  • Written quote before any work starts
  • Premium components as standard
  • Local installation and service
  • Financing and trade-in credit available

★★★★★

Rated 5.0 on Google.

Family holding glasses of clean water at home

Get started

Find out what is in your water

The in-home water test is free. We test your water, show you your Water Health Index score and give you a written quote, with no obligation.